Operation Manual

1.5V “AAA” LR03 / UM4 1.5V “AAA” LR03 / UM4 1.5V “AAA” LR03 / UM4
1.5V“AA” LR6 / UM3 1.5V“AA” LR6 / UM3 1.5V“AA” LR6 / UM3 1.5V“AA” LR6 / UM3
03
Battery Detail
BATTERY REQUIREMENTS:
Your robot is powered by 4 x “AA” size Alkaline batteries
(2 batteries in each foot - not included).
Your zombie blaster is powered by 3 x “AAA” batteries (not included).
RobotZombie™
: Base of Feet Zombie Blaster: Side View
IMPORTANT BATTERY INFORMATION:
• Use only fresh batteries of the required size and recommended type
• Do not mix old and new batteries, dierent types of batteries [standard
(Carbon-Zinc), Alkaline or rechargeable] or rechargeable batteries of dierent capacities
• Remove rechargeable batteries from the toy before recharging them
• Rechargeable batteries are only to be charged under adult supervision
• Please respect the correct polarity, (+) and (-)
• Do not try to recharge non-rechargeable batteries
re
• Replace all batteries of the same type/brand at the same time
• The supply terminals are not to be short-circuited
• Remove exhausted batteries from the toy
• Batteries should be replaced by adults
• Remove batteries if the toy is not going to be played with for some time
• Robot will just stop when battery power gets VERY low. Power o and replace all batteries.
• Some lighting or sunlight can interfere with infra-red signals.
NOTE
LOW BATTERY INDICATORS:
When RobotZombie™ ’s batteries grow weak, your RobotZombie™ will move and walk very slowly
When this occurs, power robot OFF and replace all batteries.
When the Zombie Blaster’s batteries grow weak, RobotZombie™ will no longer respond to the
commands. When this occurs, replace all batteries
BATTERY INSTALLATION:
• Be sure the robot power button is in the OFF position before installing or
changing batteries.
• Remove the battery covers with a Phillips/crosshead screwdriver as shown
(not included).
• Install recommended batteries as shown, making sure battery polarity is correct
(batteries not included).
• Replace battery doors and carefully tighten all screws.