User Manual

INSTALLING THE RECHARGEABLE BATTERY PACK
1. To install the rechargeable battery pack, carefully lay Coder MiP™ on its front.
2. Slide in the battery battery pack as indicated in Diagram A.
3. Using rm pressure, push the bottom of battery pack into place rst as indicated in
Diagram B.
4. Using a philips screwdriver, screw in the bottom two screws until the battery pack is rmly
in place, and no gaps appear between Coder MiP™ and the rechargeable battery pack.
5. Finally, screw in the top screw as indicated in Diagram D.
NOTE: If Coder MiP™ does not power on after installing the battery, ensure that the battery
is fully charged, and/or try reinstalling the rechargeable battery pack, ensuring that there are
no gaps between the battery pack and Coder MiP™.
Diagram A Diagram B
Diagram C Diagram D