Instructions

1.5V LR03
UM4 “AAA”
1.5V LR03
UM4 “AAA”
1.5V LR03
UM4 “AAA”
1.5V LR6 UM3 “AA” 1.5V LR6 UM3 “AA”
1.5V LR6 UM3 “AA” 1.5V LR6 UM3 “AA”
1.5V LR6 UM3 “AA” 1.5V LR6 UM3 “AA”
4
BATTERY DETAILS
baTTERy REquIREMENTs:
Your Roboraptor X™ is powered by 6 x “AA” size batteries (not included).
Your Remote Controller is powered by 3 x “AAA” size batteries (not included).
Your Infra-red Dongle is powered by 3 x “LR44” batteries (included).
baTTERy INsTallaTION:
1. Before installing or changing batteries, ensure the Roboraptor X™’s ON/OFF button
is in the OFF position.
2. Remove the battery compartment covers using a Phillips or crosshead screwdriver
(not included).
3. Insert batteries (not included) into the Roboraptor X™ and controller as shown in
the diagrams.
4. Replace the battery compartment covers and the screws.
aTTENTION: IMpORTaNT baTTERy INFORMaTION
• Use only fresh batteries of the required size and recommended type.
• Do not mix old and new batteries, different types of batteries (Standard (Carbon zinc),
alkaline, or rechargeable), or rechargeable batteries of different capacities.
• Remove rechargeable batteries from the toy before recharging them.
• Rechargeable batteries are only to be charged under adult supervision.
• Please respect the correct polarity, (+) and (-).
• Do not try to charge non-rechargeable batteries.
• Do not dipose of batteries into re.
• Replace all batteries of the same type/brand at the same time.
• The supply terminals are not to be short-circuited.
• Remove exhausted batteries from the toy.
• Batteries should be replaced by adults because of small parts.
• Remove batteries if the toy is not going to be played with for some time.
• The packaging has to be kept since it contains important information.
baCk VIEw
OF ThE REMOTE CONTROllER
INFRa-REd dONglE
bOTTOM VIEw
OF ThE RObORapTOR X™