Instructions

P. 3
Battery Details
BATTERY REQUIREMENTS:
Your robot is powered by 4 x “D” size Alkaline batteries (2 batteries in each foot - not included).
Your remote controller is powered by 3 x “AAA” batteries (not included).
Your infra-red dongle is powered by 3 x “LR44” batteries (included).
BATTERY INSTALLATION:
• Be sure the robot power button is in the OFF position (OUT) before installing or changing batteries.
• Remove the battery covers with a Phillips/crosshead screwdriver as shown (not included).
• Install recommended batteries as shown, making sure battery polarity is correct (batteries not included).
• Replace battery doors and carefully tighten all screws.
LOW BATTERY INDICATORS:
When Robosapien X™ ’s batteries grow weak, your Robosapien X™ will move and walk very slowly.
- When this occurs, power robot OFF and replace all batteries.
When the remote controller’s batteries grow weak, the indicator light will shine very dimly.
- When this occurs, replace all the batteries in the remote controller.
• Robot will just stop when battery power gets VERY low. Power off and replace all batteries.
• Some lighting or sunlight can interfere with infra-red signals.
IMPORTANT BATTERY INFORMATION:
• Use only fresh batteries of the required size and recommended type
• Do not mix old and new batteries, different types of batteries [standard
(Carbon-Zinc), Alkaline or rechargeable] or rechargeable batteries of
different capacities
• Remove rechargeable batteries from the toy before recharging them
• Rechargeable batteries are only to be charged under adult supervision
• Please respect the correct polarity, (+) and (-)
• Do not try to recharge non-rechargeable batteries
• Do not throw batteries into the re
• Replace all batteries of the same type/brand at the same time
• The supply terminals are not to be short-circuited
• Remove exhausted batteries from the toy
• Batteries should be replaced by adults
• Remove batteries if the toy is not going to be played with for some time
1.5V
"D"
LR20
UM1
1.5V
"D"
LR20
UM1
1.5V
"D"
LR20
UM1
1.5V
"D"
LR20
UM1
Robosapien X™ : Base of feet Infra-Red Dongle
Remote Controller:
Bottom View
1.5V "AAA"
LR03 UM4
1.5V "AAA"
LR03 UM4
1.5V "AAA"
LR03 UM4
NOTE