Specification

6.3"x2.6x0.2"
(160x66x5)
96(3.8")
4"(103)
5.1"(130)
1.2"
(31.5)
ensor window
Faucet body
Fixing nut
Gasket
Decoration Plate
water
temperature
regulator
Hot water
pipe (red)
Sensor
wire
Outlet hose
Control box
Support
Expansion rubber
Self-tapping
screws
Cold water
pipe (blue)
Gasket
Screws
Screws
Positioning seat
water inlet
water outlet
Cold
G1/2 inlet
1.Please insert the G1/2 inlet , the sensor wires through the decorative plate in order,
2.use the screws fixing the decorative plate into faucet body .
then insert the faucet into the basin, and the sensor wires should go through the basin.
The size of the hole should be 25mm.
3. Please insert sensor wires through the flat gasket and the Positioning seat in order,
4. Tighten the fixing nut, in order to fix the faucet in the basin firmly.
5.Install the control box as shown on the right.
6..Connect the water temperature regulator with the gasket to the control box inlet.
7.Connect the cold water inlet(blue) and hot water inlet(red) to the water .
temperature regulator separately.
8.Using the Outlet hose connect the faucet G1/2 inlet to the control box water outlet.
9.Plug the faucet sensor wires to the control box sensor wire plug sleeve.
10.Open the water supply, the faucet will work right away. If the faucet does not work
normally, please try to repeat step 4 to step 6, take out the batteries for several
minutes then put them back, and the faucet will work normally.
1. Open the battery box lid,
2.unscrew the screws in the battery
box at the top of the control box，
3.put the 4 pieces of D batteries into the
battery box with positive and negative direction correctly.
4. Fix back the battery box lid, ensure to tighten the screws in the battery box lid,
or the batteries will go damp and shorten the life.
Choose one location on the wall, with 6mm drill to drill two holes in the support-holes
centerline, fix the expansion rubber grain into the two holes, put the M4 flat gasket,
through the M4X30 semi-circular head self-tapping screws, then tighten a half of it into
the expansion rubber grain with a screwdriver. Then put the two big holes of the support
right through the two screws, then pull down the support (notch towards down), tighten
the two screws and fix the support on the wall.
5. Make sure the outlet of the control box is right to the notch. Pull out a little harder the
both sides of the support, force and push the control box into the support, fix the control
box in the support.
Note: Always flush pipework before installation.
The installation place which you choose and design should not be under
strong sunlight and strong light directly.
Not included the 4 pieces of D batteries
G1/2"
Ø1"(Ø25)
1.2"(30mm)
Max. deck
Thickness
3/8"
G1/2"
3/8"
Hot
Cold
unit:inch(mm)