Specification

We
Automatic Sensor Faucet is designed with infrared ray sense
principle.
With two-part system design, electronic components are inside the
faucet body, solenoid valve is inside the control box. The installation
is as easy as the normal faucet.
Hygienic
With automatic operation, hand-free from the faucet, faucet starts
flowing water once hands enter the sensor range, and stops flowing
when hands leave the sensor range. It keeps you from bacterial
infections.
Economical
The faucet only uses 4 pieces of alkaline D batteries, and can be used
for over 200,000 times flowing.
Low Power Indication
When the batteries are exhausted, the indication light will blinks
intermittently as you strength your hand in front of the faucet. It
suggests you changing batteries; if the indication light blinks
continuously, that means the batteries are gone, faucet stops
working, and batteries must be changed for new ones, and the
faucet will work again normally.
The water temperature regulator can be adjusted the water
temperature when needed. Users only need to turn the lever,
clockwise for cold water, counterclockwise for hot water.
TECHNICAL SPECIFICATION
Dia. Of Inlet and outlet
Pipe G1/2"
Water Pressure 0.05-0.6MPa
(0.5-6Kgf/cm2)
Power Consumption ≤0.5mW
Power DC:3V
(4 pieces of alkaline D batteries)
Sensor Range
Lower sensor: The faucet will adjust the
sensor range automatically after being set
down in 6 seconds in the basin.
Water Temperature 4℃-50℃
Important Notice:
Products will go damage if water temperature is lower than 4℃ or
higher than 50℃.