Installation Guide

5
FLUSH SYSTEM/CHECK FOR LEAKS.
Turn on hot and cold water supplies and
flush water lines for one minute.
Check all connections at arrows for
leaks.
Retighten if necessary, but do not
overtighten.
2
Hot hose
Cold hose
1.Make sure attach the O-ring(1) to the
faucet body.
2.Slide tubes down through mounting hole
on sink.
Option: If sink is uneven, use silicone under
the faucet body.
3.Place washer(2) and metal plate(3) over
mounting stud under sink.
Secure with mounting nut(4).
2
3
4
Before installing the valves, clean the
water pipe thoroughly
to avoid dirt
and deposits.
Notes
1
4
Secure metal nut on faucet supply
hoses to supply valve connection
and hand tighten,
then tighten one additional revolution
with wrench.
DO NOT OVERTIGHTEN.
Repeat for other hose connection
making sure the hose with the hot label
is connected to the hot supply valve and
the other hose is connected to the cold
supply valve.
WARNING: Do not use pipe dope or
other sealants on water connections.
Hot
Cold
Cold hose
Hot hose
1
3
Attach flexible
hoses under the
faucet body.
Attach mounting
stud under faucet
body
1