User's Manual

ManualsBrandsWow! Stuff ManualsElectronicsAttacknid, Combat Creatures

4. Preparing your Attacknid

for battle. Placing the Combat

Armor onto the legs.

Align the two bottom pins

on the armor with the two

bottom holes in each leg

(see Figure 4.)

Then firmly push the

bottom two pins into the

bottom of the leg, as the

armor is spring loaded.

6. When a direct hit occurs to the

Combat Armor then it pings off

(see figure 6.)

The aim is to remove all your

opponents armor!

For more information on Battle

Modes go to page 10.

5. They simply click and lock into

position (see Figure 5.)

12.

www.combatcreatures.com

This de

vice complies with Part 15 of the FCC Rules.

Oper

ation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may cause

undesired operation.

WARNING: Changes or modifications to this unit not expressly approved by the party

responsible for compliance could void the users authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provided

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the user

is encouraged to try to correct the interference by one or more of the following measures:

· Reorient or relocate the receiving antenna.

· Increase the separation between the equipment and receiv

er.

· Connect the equipment into an outlet on a circuit different from that to which the receiv

is connected.

· Consult the dealer or an experienced radio

/TV technician for help.

The manufacturer is not responsible for any radio or TV interference caused by unauthorized

modifications to this equipment. Such modifications could void the user’s authority to

operate the equipment.

Combat Armor