Instruction manual

Reciprocating saw WX80RS
speed once the cut has started. With the blade guard
held firmly against the work surface, start a slow but
controlled upward swing of the saw. The blade will
cut into and through the material. Always ensure
the blade is completely through the material before
cutting the remainder of the pocket.
WOrK HIntS fOr yOur
reCIPrOCatInG SaW
If your power tool becomes too hot, set the speed to
maximum and run a no load for 2-3 minutes to cool the
motor.
Always ensure the work-piece is firmly held or clamped
to prevent movement.
The blade guard must be held firmly against the
material being cut to reduce saw vibration, blade
jumping and blade breakage.
MaIntenanCe
Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
Your power tool requires no additional lubrication
or maintenance. There are no user serviceable parts
in your power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean with
a dry cloth. Always store your power tool in a dry
place. Keep the motor ventilation slots clean. Keep
all working controls free of dust. Occasionally you
may see sparks through the ventilation slots. This
is normal. If the supply cord is damaged, it must be
replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
H2