Instruction manual

Reciprocating saw WX80RS

OPeratInG InStruCtIOnS

NOTE: Before using the tool, read the

instruction book carefully.

1. ON/OFF SWITCH

Depress the button to start and release it to stop your

tool.

2. VARIABLE SPEED CONTROL

Your tool is equipped with a variable speed controlled

trigger switch. The tool can be turned “ON” or

“OFF” by squeezing or releasing the trigger. The

blade plunger stroke rate can be adjusted from the

minimum to maximum by the pressure you apply

to the trigger. Apply more pressure to increase the

speed and release pressure to decrease speed (See A)

3. HAND GRIP AREAS

Always hold your saw ﬁrmly with both hands when

operating (See A).

4. TOOL-LESS BLADE FITTING

To install the blade (See Fig B and Fig C), disconnect

the saw from power supply. If necessary, extend the

pivoting blade foot away from the blade clamp for

easier access. Pull the tool-less blade clamp lever

(3) up with your thumb, as shown. Insert the blade

into the saw’s blade clamp and make sure that the

blade attaches to the blade pin inside the clamp. Push

down blade clamp lever (3) ensure the blade is locked

securely in place.

To remove Blade (See Fig B and Fig C)

Disconnect saw from power supply. If necessary,

extend the pivoting blade foot away from the blade

clamp for easier access. First, pull the blade clamp

lever (3) up with your thumb, and then pull the blade

out of the blade clamp.

5. PIVOTING BLADE FOOT ADJUSTMENT

If you need to reduce the cutting capacity of your

tool the pivoting blade foot (4) may be adjusted as

follows: Using the hex key provided, loosen the two

screws on the underside of the front housing (See Fig

D). Slide the pivoting blade foot to give the required

distance from the end of the blade (See Fig D) to

the pivoting blade foot (This distance equals new

cutting capacity). Then securely tighten both screws.

The pivoting blade foot slide is now locked but the

pivoting blade foot will continue to pivot, as it must