SAFETY AND OPERATING MANUAL Reciprocating saw WX80RS
General Safety Rules WARNING! Read all instructions. Failure to follow all instructions listed below may result in electric shock, fire and/ or serious injury. The term “power tool” in all of the warnings listed below refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. SAVE THESE INSTRUCTION 1. Work area 1) Keep work area clean and well lit. Cluttered or dark areas invite accidents.
2) 3) 4) 5) 6) 7) do the job better and safer at the rate for which it was designed. Do not use the power tool if the switch does not turn it on and off. Any power tool that cannot be controlled with the switch is dangerous and must be repaired. Disconnect the plug from the power source and/or the battery pack from the power tool before making any adjustments, changing accessories, or storing power tools. Such preventive safety measures reduce the risk of starting the power tool accidentally.
13. Always check walls, floors and ceilings to avoid hidden power cables and pipes. 14. After long working period, external metal parts and accessories could be hot. 15. Always hold the saw firmly with both hands when operating. 16. Only withdraw the blade from the cut when the blade has been stopped moving. 17. The pivoting blade foot must be held firmly against the material being cut to reduce saw vibration, blade jumping and blade breakage. 18.
4 3 5 2 1 2 1. On/Off Trigger Switch 2. Hand Grip Areas 3. Tool-Less Blade Clamp Lever 4. Pivoting Blade Foot 5. Blade * 6. Hex Key 6 * Not all the accessories illustrated or described are included in standard delivery.
TECHNICAL DATA Rated voltage 220-240V~50/60Hz Rated power 800W Rated no load speed 0-2600/min Stroke length Cutting capacity max 28mm Wood (thickness) 280mm Thin pipe (diameter PVC pipe) 150mm Steel (thickness) 13mm Double insulation /II Weight 3.8kg ACCESSORIES Assorted blades (1pc for metal; 1pc for wood; 1pc for aluminium/plastic) Hex key 3pc 1pc We recommend that you purchase your accessories from the same store that sold you the tool.
OPERATING INSTRUCTIONS Note: Before using the tool, read the instruction book carefully. 1. ON/OFF SWITCH Depress the button to start and release it to stop your tool. 2. VARIABLE SPEED CONTROL Your tool is equipped with a variable speed controlled trigger switch. The tool can be turned “ON” or “OFF” by squeezing or releasing the trigger. The blade plunger stroke rate can be adjusted from the minimum to maximum by the pressure you apply to the trigger.
follow your work surface. 6. PIVOTING BLADE FOOT The pivoting blade foot must be held firmly against the material being cut to reduce saw vibration, blade jumping and blade breakage. E F G H1 7. FLUSH CUTTING It is possible to make cuts extremely close to floors, walls and other difficult areas. Insert the blade shank into the blade clamp with the blade teeth facing up (opposite to normal working position). This will make cuts closer to the work surface (See Fig E).
speed once the cut has started. With the blade guard held firmly against the work surface, start a slow but controlled upward swing of the saw. The blade will cut into and through the material. Always ensure the blade is completely through the material before cutting the remainder of the pocket. WORK HINTS FOR YOUR RECIPROCATING SAW H2 If your power tool becomes too hot, set the speed to maximum and run a no load for 2-3 minutes to cool the motor.
Copyright © 2011, Positec. All Rights Reserved.
