Use And Care Manual

1312
Cordless Circular Saw EN
12
TROUBLESHOOTING
Symptom Possible Causes Possible Solution
Tool will not start when
operating the on/off switch.
Battery pack not plugged in.
Battery pack is powered off.
Carbon brush has worn down.
Check to make sure battery pack
is connected well into a working
outlet.
Charging the battery.
Replace the carbon brush using a
qualified maintenance person.
Cutting depth is less than
that is set.
Sawdust accumulated at the rear of
the base.
Shake out sawdust. Consider
connecting a vacuum for dust
collection.
Blade spins or slips Blade is not tightly engaged with the
spindle.
Remove the blade, and
reassemble it as described in
Saw Blade Assembly and
Removing section.
Blade will not cut a straight
line.
Blade is dull.
Blade is not mounted properly.
Saw is not being guided properly.
Mount a new, sharp blade on the
saw.
Check that blade is properly
mounted.
Use a parallel guide.
Blade kicks back when
beginning a cut
Blade is not spinning fast enough Allow the saw blade to reach full
speed prior to beginning a cut in
the material.