Operation Manual

15
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
INTENDED USE (FOR WX175 WX175.1 WX175.2
WX175.9)
The machine is intended for driving in and loosening
screws as well as for drilling in wood, metal and plastic.
INTENDED USE (FOR WX373 WX373.1 WX373.2
WX373.9)
The machine is intended for impact drilling in brick,
concrete and stone as well as for drilling in wood, metal
and plastic.
ASSEMBLY AND OPERATION
ACTION FIGURE
BEFORE OPERATION
Checking the battery charge condition See Fig. A1
Removing the battery pack See Fig. A2
Charging the battery See Fig. A3
Installing the battery pack See Fig. A4
ASSEMBLY
CHUCK ADJUSTMENT
WARNING: Always lock off trigger switch and
disconnect tool from power source when changing
accessories. Always ensure the bit is secure before
starting the tool. Damage to the Chuck or a loose bit may
cause possible personal injury.
-- Removing the bits See Fig. B1
-- Inserting the bits See Fig. B2
Assembling the belt hook and bit clip
See Fig. C1, C2,
C3, C4
OPERATION
FORWARD/REVERSE ROTATION
CONTROL
WARNING: Never change the
direction of rotation when the
chuck is rotating, wait until it has
stopped!
See Fig.D1,
D2, D3
TWO-SPEED GEAR CONTROL
See Fig. E
TORQUE ADJUSTMENT
SCREWDRIVING, DRILLING,
HAMMER DRILLING
See Fig. F1,
F2, F3
OPERATING THE ON/OFF
SWITCH
WARNING: Do not operate for
long periods at low speed
because excess heat will be
produced internally.
See Fig. G