Technical data

9
Speed Table
Material Router bit-Ø Speed stages
Hardwood
(Beech)
4 – 10 mm 5–6
12 – 20 mm 3–4
22 – 40 mm 1–2
Softwood
(Pine)
4 – 10 mm 5–6
12 – 20 mm 3–6
22 – 40 mm 1–3
Particle board 4 – 10 mm 3–6
12 – 20 mm 2–4
22 – 40 mm 1–3
Plastic 4 – 15 mm 2–3
16 – 40 mm 1–2
Aluminium 4 – 15 mm 1–2
16 – 40 mm
1
The values shown in the chart are standard values. The necessary
speed depends on the material and the operating conditions, and can
be determined by practical testing.
Constant electronic control and soft start (Only for
WU601&WU601.1)
Constant electronic control maintains the speed constant at no-load
and under most working conditions. Soft start delays the increase in
motor speed to reduce the motor “kick” or torque effect to improve
operator comfort and safety.
MOUNTING THE EXTRACTION ADAPTER (See B)
To connect the vacuum cleaner via a suction hose, you must fasten
dust adapter (20) to base plate (10) with both knurled screws (25).
When mounting the extraction adapter, ensure correct
mounting position!
• For dust extraction, the vacuum hose can be connected directly to
the extraction adapter.
• Clean the dust adapter (20) regularly to ensure optimum dust
extraction at all times.
• The vacuum cleaner must be suitable for the material to be worked.
• When vacuuming dry dust that is especially detrimental to health or
carcinogenic, use a special vacuum cleaner.
ON AND OFF SWITCH
For starting the machine, actuate the lock-off button (16) first, and
then press and hold the On/Off switch (18) afterwards.
Speed Pre-selection
The required speed can be pre-selected with the thumb-wheel (17)
(also whilst running).
1 – 2 = low speed
3 – 4 = medium speed
5 – 6 = high speed
The required speed is dependent on the material and can be
determined by practical testing.
After longer periods of working at low speed, allow the machine to
cool down by running it for approx. 3 minutes at maximum speed
with no load.
2
3