Instruction Manual

AUTOMATIC SPINDLE LOCK (See F)

The automatic spindle lock allows you to use it as a regular

screwdriver. You can give an extra twist to ﬁrmly tighten a screw,

loosen a very tight screw or continue working when the battery

energy has expired. For manual screwdriver purposes, the chuck is

automatically locked when the tool is off.

USING THE LED LIGHT

To turn on the light simply press the on/off switch. When you release

the on/off switch, the light will be off.

LED lighting increases visibility-great for dark or enclosed area. LED is

also a battery capacity indicator. It will ﬂash when power gets low.

DRILLING

When drilling into a hard smooth surface, use a center punch to mark

the desired hole location. This will prevent the drill bit from slipping

off center as the hole is started. Hold the tool ﬁrmly and place the tip

of the bit at the point to be drilled. Depress the switch trigger to start

the tool. Move the drill bit into the workpiece, applying only enough

pressure to keep the bit cutting. Do not force or apply side pressure

to elongate a hole.

Tungsten carbide drill bits should always be used for

concrete and masonry. When drilling in metal, only use HSS

drill bits in good condition. Always use a magnetic bit holder

(not included) when using short screwdriver bits. When screw-

driving, apply a small quantity of liquid soap or similar to the

screw threads to ease insertion.

A B

C D