Installation Guide

7
EN
2
6
c
m
26cm
2
6
c
m
35% (20°)
The slope would be:
35cm (Elevation)
100cm (Length)
=35% (slope)
Placement of boundary wire on slopes
The upper boundary wire should NOT be placed on slopes
steeper than 35% (20°), and it should be placed at a distance of
26cm from any obstacle. The lower boundary wire should NOT
be placed on slopes steeper than 17% (10°), and it should be
placed at least 40cm away from any obstacle when positioned
on a slope that is 17%.
NOTE: The lower boundary wire cannot be laid across a slope
steeper than 17% as Landroid
®
will slip and cross outside the
wire, especially when the grass is wet.
Placement of boundary wire at a corner
If you want Landroid
®
to turn a right angle, lay down the
boundary wire as the illustration shown.
Upper boundary wire
Lower boundary
Wire
Lower boundary
Wire
**How to calculate the slope of your lawn:
100cm
35cm
Length
Elevation
Max. 35% slope
Max.10cm
Max.2.5cm
Max.2cm
Depressions and bumps
In case of large bumps (higher than 2cm) or dips (wider than
10cm and deeper than 2.5cm), please determine if the blades
would touch the ground or if Landroid
®
would get stuck. If
this is the case, either make the inclines smoother or exclude
these areas from Landroid
®
’s operation.
Slopes
Your Landroid
®
has the ability to safely climb slopes up to
35% (20°)**, so please avoid areas steeper than this.