Installation Guide

75cm75cm

10cm

.5m

26cm

>1m

Complete the entire boundary wire setup

Lay down the boundary wire around the working area as the

illustration shown.

After pegging the boundry wire, please take your Landroid

away from the charging base. Lead the boundary wire back to

the charging base, leave a length of the boundary wire (OUT-

wire) around 80cm and cut it off. Insert both wire ends into the

grooves on the charging base. Peel off the plastic skin at the end

of both wires (around 1cm), and connect the naked metal wire

end of the IN-wire to the BLACK terminal and the end of OUT-

wire to the RED terminal.

NOTE: If you need to extend the boundary wire, please refer

to “Joining the Boundary Wire” in Owner’s Manual for

instructions.

IN WIREOUT WIRE

OUT