Installation Guide

11
EN
Charge your Landroid
®
before the first operation
When connecting the power cord of the charging base to the
adapter, align the notch on the power cord (b) with the groove on
the adapter (a).
Connect the adapter to the electrical outlet. The LED on the
charging base will turn on in red color. Manually dock Landroid
®
into the charging base while Landroid
®
is powered off. The green
light on the charging base will turn green and Landroid
®
will
begin to charge.
If the power cord is in Landroid
®
's working area, you may bury it
if desired.
NOTE: If you want to plug the adapter in an indoor electrical
outlet, you need to route the power cord through the hole in the
wall.
Peg the boundary wire
Before pegging the boundary wire, it is recommended to use a
normal lawn mower or a grass trimmer to cut the grass along
the boundary. Then the wire should be laid as close as possible
to the ground to prevent your Landroid
®
accidentally cutting the
wire. The boundary wire is powered with a very low voltage
totally safe to humans and pets.
Pull out a length of boundary wire around 80cm and fasten it
to the ground near the charging base. Later, this end of the
boundary wire (IN-wire) will be connected to the BLACK terminal
after pegging your boundry wire.
NOTE: The extended boundary wire should not exceed 400m or
it may cause signal problem.
2
3
ba
a
b
80cm
WR130E WR131E
WR141E WR144E
BLACK
RED