User Manual

2 in 1: Pole Saw / Chain Saw EN
18
at end of inner pole.(See Fig. G2)
WARNING!
• Before attaching the power cord of
the machine to the power cord of the
Extension Pole, make sure that the
tool is switched off and unplugged
from the power supply.
• When using this machine with the
Extension Pole, make sure to first
attach the power cord of the machine
to the power cord of the extension
pole, and then attach the power
cord of the extension pole to power
supply.
• ELECTROCUTION HAZARD:
Never use the Saw or Extension Pole
in an area with overhead power lines
or where the branch being cut can
come into contact with overhead
power lines.
ADJUSTING POLE LENGTH
The pole saw has a telescoping pole
assembly that will extend from 87 inches
(fully retracted) to 117 inches (fully extended).
A cam levered collet is used to hold the pole
in position at any extended length.
1. To extend the pole, loosen the clamping
lever as shown in Fig H. Pole will slide
freely.
2. Pull inner pole section out to desired
length of extension. Note: only extend pole
to minimum length required to reach limb
that is being cut.
3. To lock pole in position, tighten clamping
lever as shown in Fig. H.
LUBRICATION
IMPORTANT: The chain saw is
not supplied filled with oil. It is
essential to fill with oil before use.
Never operate the chain saw without
chain oil or at an empty oil tank level, as
this will result in extensive damage to
the product.
NOTE: Chain life and cutting capacity depend
on optimum lubrication. Therefore, the chain
is automatically oiled during operation.
Filling oil tank:
1. Set chain saw on any suitable surface with
Oil Filler Cap (5) facing upward.
2. Clean area around the Oil Filler Cap with
cloth and unscrew the cap by turning it
counter clockwise.
3. Add WORX bar and chain oil until reservoir
is full.
4. Avoid dirt or debris entering oil tank, refit
Oil Filler Cap (5) and tighten by turning
clockwise until hand tight.
IMPORTANT: To allow venting of
the oil reservoir, small breather
channels are provided between the Oil
Filler Cap and the strainer, to prevent
leakage ensure machine is left in a
horizontal position (Oil Filler Cap (5)
uppermost) when not in use.
It is important to use only the
recommended standard bar and chain
oil (Grade: ISO VG32) to avoid damage
to the chain saw. This can be found at
the location you purchased this saw or
your local hardware store. Never use
recycled/old oil. Use of non approved oil
will invalidate the warranty.
Checking the Automatic Oiler
Proper functioning of the automatic oiler
can be checked by running the chain saw
and pointing the tip of the Guide chain bar
(7) towards a piece of cardboard or paper
on the ground. If an increasing oil pattern
develops on the cardboard, the automatic
oiler is operating fine. If there is no oil pattern,
despite a full oil reservoir, contact WORX
customer service agent or WORX approved
service agent.
CAUTION: Do not touch the ground
with the chain. Ensure safety
clearance of 12”.
OPERATION
1. SWITCHING ON AND OFF (See Fig. I)
ATTENTION: Check the voltage and
current supply: The voltage and
current supply must comply with the
ratings on the product plate.
For switching on the tool, press the Lock-
off Button (3), then fully press the On/Off