Use and Care Manual

14
3-in-1 Cordless Lawn Mower EN
ASSEMBLY & OPERATION
NOTE: Read instruction handbook before
operation this machine.
ASSEMBLY & OPERATION
Action Figure
ASSEMBLY
Assembling the handle bar See Fig. A1
Adjustment Handle’s height See Fig. A2
Assembling the grass collection bag See Fig. B
Assembling the grass collection bag to
the lawn mower
NOTE: Depress the grass collection
bag slightly to ensure that it is
completely installed.
NOTE: Take the mulching insert out
of the lawn mower before fitting the
grass collection bag.
See Fig. C1,
C2, C3
Removing/emptying grass collection
bag
WARNING! Always check the
safety flap close the discharge
outlet before using. Never lift the
safety flap when the lawn mower is
being used without fitted grass
collection bag.
See Fig. D
Installing side-discharge chute
See Fig. E1
E2
Installing mulching insert See Fig. F
Removing /fitting the battery pack
NOTE: This machine will only run
when 2 batteries are installed. It is
recommended to use the same two
batteries and charge the two batteries
at the same time.
When you use two batteries with
different power, the machine will
only run to the lower common
denominator.
See Fig. G1,
G2
Checking the battery charge
condition
NOTE: Fig. H1 only applies for the
battery pack with battery indicator
light.
See Fig. H1
Charging the battery pack
NOTE: The batteries are shipped
uncharged. Each battery must be fully
charged before the first mow.
Always fully charge the two batteries
at same time. More details can be
found in charger’s manual.
See Fig. H2
OPERATION
Power indicator light
See details in BATTERY STATUS part
IMPORTANT:
When only one light is illuminated,
your battery is overly discharged,
even though the machine may still
be capable to work. Continuing
to operate your machine with
the battery in this discharged
condition may reduce the life and
performance of your battery.
When no light is illuminated,
at least one battery is not fully
installed or battery may be
defective, please double check
the batteries are fully seated into
position.
See Fig. J
Starting and Stopping
See Fig. K1,
K2, K3
Adjusting the cutting height
WARNING! Stop, release switch
lever and wait until the motor
stops before adjusting height. The
blades continue to rotate after the
machine is switched off, a rotating
blade can cause injury. Do not touch
rotating blades.
See Fig L
Storage
See Fig. M1,
M2
BATTERY STATUS (See Fig. J)
• Before starting or after use, press the button
beside the power indicator light on the machine to
check the battery capacity.
15
16
14
1
2
3
4
5
6
7
1——1-1/4”
(30mm)
2——1-1/2”
(38mm)
3——2”
(51mm)
4——2-1/2”
(64mm)
5——3”
(76mm)
6——3-1/2”
(89mm)
7——4”
(100mm)
1
2
O-1
O-2
O-3
11
100%
0%
J
O P1
P2
K1
K2
K3
L
M1
M2
N
H2
H1