Instruction manual

Cordless Li-Ion

Blower/Sweeper

WG568E WG568E.9

ASSEMBLY

ASSEMBLING THE BLOWER TUBE (See Fig. A & B)

ALWAYS REMOVE THE BATTERY PACK BEFORE

ASSEMBLING THE BLOWER TUBE

Fit the Blower Tube to the motor housing as shown in

Fig. A. Check the Blower Tube is ﬁrmly secured.

NOTE: Before disassembling the Blower Tube, be sure

the variable speed trigger is on off position. Press the

Release Button (7), so that you can separate the tube

(See Fig. B). Do not try to separate the tubes by force or

by using tools.

OPERATION

INTENDED USE:

The blower is intended for blow debris. It’s not intends

for use indoors and animal grooming.

WARNING! The charger and battery pack

are specially designed to work together so

do not attempt to use any other devices. Never

insert or allow metallic objects into your charger

or battery pack connections because of an

electrical failure and hazard will occur.

1. BEFORE USING YOUR CORDLESS BLOWER

Your battery pack is UNCHARGED and you must charge

once before use.

The battery charger supplied is matched to the Li-ion

battery installed in the machine. Do not use another

battery charger.

2. CHARGING YOUR BATTERY PACK

The Li-Ion battery is protected against deep

discharging. When the battery is empty, the machine is

switched off by means of a protective circuit:

In a warm environment or after heavy use, the battery

pack may become too hot to permit charging. Allow

time for the battery to cool down before recharging.

3. TO REMOVE OR INSTALL BATTERY PACK

(See Fig. C)

Depress the Battery Release Button (9) to release

battery pack from your tool. After recharging, insert the

battery pack into tool’s battery port. A simple push and

slight pressure will be sufﬁcient.

4.BATTERY STATUS LED’S (See Fig. D )

NOTE: The Status LED’s will indicate the battery

condition when the button on the battery is pressed.

The LED’s constantly senses and displays the battery