Instruction manual

Cordless Li-Ion Blower/

Sweeper

WG549E WG549E.5

WG549E.9

ASSEMBLY

ASSEMBLING THE BLOWER TUBE

(See Fig. A & B)

Before assembling the Blower Tube (4), be sure the

On/Off Switch (2) is in ‘’O’’ Off position.

Fit the Blower Tube to the motor housing as shown in

Fig. A. Check the Blower Tube is ﬁrmly secured.

WARNING! Do not attempt to operate or

disable the On/Off Switch by any means

other than the normal assembly or removal of

the tube.

NOTE: Before disassembling the Blower Tube, be sure

the On/Off Switch (2) is in ‘’O’’ Off position. Press the

Release Button (3), so that you can separate the tube

(See Fig. B). Do not try to separate the tubes by force

or by using tools.

OPERATION

INTENDED USE:

The blower is intended for blow debris It’s not

intended for use indoors and animal grooming.

WARNING! The charger and battery pack

are specially designed to work together so

do not attempt to use any other devices. Never

insert or allow metallic objects into your

charger or battery pack connections because of

an electrical failure and hazard will occur.

1. BEFORE USING YOUR CORDLESS BLOWER

Your battery pack is UNCHARGED and you must

charge once before use.

The battery charger supplied is matched to the Li-ion

battery installed in the machine. Do not use another

battery charger.

2. CHARGING YOUR BATTERY PACK

The Li-ion battery is protected against deep

discharging. When the battery is empty, the machine is

switched off by means of a protective circuit:

In a warm environment or after heavy use, the battery

pack may become too hot to permit charging. Allow

time for the battery to cool down before recharging.

3. TO REMOVE OR INSTALL BATTERY PACK

(See Fig. C)

Depress the Battery Release Button (6) to release