Technical data

Limbing and trimming electric chain saw EN
2120
2120
TROUBLESHOOTING
If your saw does not operate correctly check the following:
PROBLEMS POSSIBLE CAUSES POSSIBLE SOLUTION
•Toolwillnotstart.
•Fuseblownorbreaker
tripped.
•Extensioncordnotplugged
in.
•Checkfuseorbreaker.
•Checktomakesure
extension cord is plugged
into a working outlet.
•Bar/chainoverheated.
•Chaintootight.
•Lubricationneeded.
•RefertoADJUSTING THE
CHAIN TENSION section.
•RefertoLUBRICATION
section.
•Chainisloose. •Chaintensionsetincorrectly.
•RefertoADJUSTING THE
CHAIN TENSION section.
•Poorcutquality.
•Chaintensionsetincorrectly.
•Chainneedsreplacement.
•RefertoADJUSTING THE
CHAIN TENSION section.
NOTE: Excessive tension
leads to excessive wear and
reduction in life of bar &
chain.
•Refertosectionsfor
CHANGING THE GUIDE
BAR AND CHAIN.
•Unitrunsbutdoesnotcut.
•Chaininstalledbackwards.
See Fig E and illustration.
•RefertoCHANGING THE
GUIDE BAR AND CHAIN
section.
ENVIRONMENTAL PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools and packaging
should be sorted, taken to the local recycling centre and disposed of in an environmentally
safe way.