Technical data

Limbing and trimming electric chain saw EN
1918
1918
CUTTING WITH EXTENSION POLE (ONLY
FOR WG308E)
1. Attached the pole as described in
‘’Assembling the extension pole’’.
2. Connect the JawSaw to extension cord.
Connect extension cord to power supply.
NOTE: The JawSaw is quite heavy on the
end of the extension pole.
Add the pole attachment when cutting
limbs above shoulder height and remove
the pole saw when cutting limbs at or
below shoulder height.
3. Lift JawSaw with extension pole upward
one step by one step (See Fig. AA). To raise
to the vertical position, lift by the Jawsaw
first, then hand over hand along the pole.
4. Before cutting a high branch, consider all
the same points detailed in the previous
section “Trimming Branches” but pay
particular attention to the likely path of the
falling branch.
WARNING: Do not stand directly
below a branch being cut. Keep
bystanders far away. Do not stand on a
ladder or other type of unstable support
while using the tool. Do not use the tool
near cable, electrical power or telephone
lines. Keep 3m away from all power
lines. (See Fig. AB1-AB4)
5. Position the Jaw perpendicularly on the
branch being cut.
NOTE: Maximum cutting capacity of
JawSaw is 100mm.
6. One hand should firmly grip the push
handle of the extension pole. The other
hand should hold the metal portion of the
pole or the sliding handle on the pole (See
Fig. AC).
7. Complete the cut as described in
“Trimming Branches”.
8. At the completion of the cut, be ready to
immediately support the weight of the
entire tool as the branch falls.
WARNING: Do not let the JawSaw
fall to the ground at the completion
of the cut, this may damage the tool.
SAW MAINTENANCE AND
KICKBACK SAFETY
Follow maintenance instructions in this
manual. Proper cleaning of saw and chain and
guide bar maintenance can reduce chances of
kickback. Inspect and maintain saw after each
use. This will increase the service life of your
saw.
NOTE: Even with proper sharpening, risk of
kickback can increase with each sharpening.
MAINTENANCE AND
STORAGE OF JAWSAW
1. Unplug the JawSaw from power source:
• Whennotinuse.
• Whentransporting.
• Whenleftunattended.
• Beforeservicing.
• Beforettingtheextensionpole.
• Beforecleaning.
• Beforechangingaccessoriesor
attachments, such as saw chain and guard.
2. Inspect the saw before and after each use
for:
• Anysignsofdamage,especiallythepower
cord.
• Smoothactionofpushhandleand
movement of bar.
• Adequatechaintension.
• Adequatechainlubrication.
3. Do not use the JawSaw, if:
• Thetriggerswitchorlockoutis
malfunctioning.
• Thepushhandledoesnotsmoothlyreturn
under spring force.
• Anyotherdamagewhichaffectsthesafety
or operation is evident.
4. Maintain the JawSaw with care and have
any damage or malfunction repaired by an
authorized service center:
• NeverexposetheJawSawtorain.
• Keepchainsharp,clean,andlubricatedfor
better and safer performance.
• Followstepsoutlinedinthismanualto
sharpen chain.
• Keephandlescleanandfreefromoil.
• Keepallscrewsandnutstight.