Technical data

1312
Limbing and trimming electric chain saw EN
1312
SYMBOLS INTENDED USE
This JawSaw has been designed for pruning
branches and cutting small logs up to 100mm
in diameter, not for cutting metals (See Fig. A).
ADJUSTMENT AND
ASSEMBLY
WARNING: Before touching
the chain or making any other
adjustments, make sure that the tool is
switched off and unplugged.
CHAIN TENSION
ADJUSTMENT
All saw chains wear and become loose from
operation. Periodically check the chain, if there
is any visible gap between the chain and the
guide bar, it must be re-tensioned.
WARNING: Unplug JawSaw from
power source before adjusting saw
chain tension.
WARNING: Cutting edges on chain
are sharp. Use protective gloves
when handling chain.
This product comes fully assembled. However,
we recommend that you check the chain
tension before use and readjust if necessary.
ADJUSTING THE CHAIN
TENSION
1. Push the handle until the bar is in the
middle of the jaw opening as shown. (See
Fig. B) Lock the bar in the middle position
by inserting the lock pin (17) found on the
power cord into the lock pin receptacle (18)
located under the handle.
2. Open the chain access cover (12) by
using the supplied wrench. To open turn
the access cover bolt 1/4 turn counter-
clockwise. (See Fig. C)
3. Release tension on the chain by loosening
the chain tensioner bolt. Turn the chain
tension bolt (15) counter clockwise 2 or
more times. (See Fig. D)
Read the manual
Warning
Wear eye protection
Wear ear protection
Wear dust mask
Do not expose to rain
Remove plug from the mains
immediately if the cable is
damaged or cut.
Double insulation
Waste electrical products should
not be disposed of with household
waste. Please recycle where
facilities exist. Check with your
Local Authority or retailer for
recycling advice.