Technical data

WG307E WG308E

Limbing and Trimming

Electric Chain Saw

INTENDED USE

This JawSaw has been designed for pruning branches

and cutting small logs up to 100mm in diameter, not

for cutting metals (See Fig. A).

ADJUSTMENT AND ASSEMBLY

WARNING: Before touching the chain or

making any other adjustments, make sure

that the tool is switched off and unplugged.

All saw chains wear and become loose from

operation. Periodically check the chain, if there is any

visible gap between the chain and the guide bar, it

must be re-tensioned.

WARNING: Unplug JawSaw from power

source before adjusting saw chain

tension.

WARNING: Cutting edges on chain

are sharp. Use protective gloves when

handling chain.

This product comes fully assembled. However, we

recommend that you check the chain tension before

use and readjust if necessary.

ADJUSTING THE CHAIN TENSION

1. Push the handle until the bar is in the middle of the

jaw opening as shown. Lock the bar in the middle

position by inserting the lock pin (17) found on the

power cord into the lock pin receptacle (18) located

under the handle (See Fig. B1-B3).

100mm

3mm

back

front