Technical data

WG307E WG308E

Limbing and Trimming

Electric Chain Saw

LUBRICATING SPROCKET

Note:

It is not necessary to remove the chain or bar when

lubricating the sprocket

1. Clean the bar and sprocket.

2. Using a grease gun, insert the tip of the gun into the

lubrication hole (h) and inject grease until it appears at

the outside edge of the sprocket tip (See Fig. AD).

3. To rotate the sprocket and pull the chain by hand until

the ungreased side of the sprocket is in line with the

lubrication hole (h). Repeat the lubrication procedure.

CLEANING

Regularly open the chain access cover and remove any

debris that has become trapped.

Regularly clean the ventilation slots with a clean, dry

paint brush.

To clean the tool, use only mild soap and a damp

cloth. Never let any liquid get inside the tool and never

immerse any part of the tool into liquid.

TRANSPORTING

Always transport the tool with the guide bar and chain

inside the protection guard.