Technical data

12
WG307E WG308E
Limbing and Trimming
Electric Chain Saw
10.Check if all parts are seated properly (See Fig J).
11.Refit and tighten the chain tensioner bolt. Note the
cam (e) of the tensioner will engage the projecting tab
(f) of the bar mounting plate and push the bar outward
to tension the chain, check for correct tension (See
Adjusting the chain tension).
12.Close the access cover and remove the lock pin.
LUBRICATION
IMPORTANT: The JawSaw is shipped with
an empty oil tank. It is essential to fill
with chain oil before use. Bar and chain oil of
any brand can be used.
Never operate the JawSaw without chain oil or
an empty tank as this will result in poor cutting
performance, motor overload and possible
burn-out.
FILLING OIL TANK: UNPLUG THE TOOL BEFORE
FILLING WITH OIL.
1. Fill oil bottle with bar oil.(See Fig. K)
2. Rest the JawSaw with the oil filler (6) facing
upward.
3. Uncrew the oil filler cap (g) open.
4. Use bottle to fill oil reservoir (See Fig. L).
5. Screw the oil filler cap (See Fig. M).
IMPORTANT: Use only the recommended
oil to avoid damage to the JawSaw. Never
use recycled/old oil. Use of non approved oil will
invalidate the warranty.
CHECKING THE AUTOMATIC OILER
The JawSaw uses a much lower chain speed than a
conventional chainsaw so it needs much less oil.
However it is very important that it always has oil.
Check the oil level window (5) and refill as necessary.
During operation, periodically check the chain and
bar. A slight oil presence should be visible. If the chain
and bar appear completely dry, then remove the bar
and chain (see previous section) to ensure the bar oil
hole is not blocked.
If the oil hole is clear, there is oil in the tank and still no
oiling of the chain is visible – contact Worx customer
service.
100mm
18
12
15
a
3mm
a
back
b
c
f
front
11
e
d
10
16
I
II
2
4
I
I
I
II
II
6
g
5
17
17
A
B3
B2
B1
C
FF
E
D
G1
I
H
G2
J
M
L
K
N
P2
P1
O