Technical data

11
WG307E WG308E
Limbing and Trimming
Electric Chain Saw
7.Before re-fitting the bar, check that the small oil
hole (b) and chain slot (c) are not blocked by dirt or
sawdust, use a small toothpick to clean if necessary
(See Fig. G1,G2).
8.Refit the chain to the bar. Note the correct direction
of the teeth (See Fig. H). The cutting direction is
inward on the lower cutting edge.
9.With the mounting plate (a) toward the motor and
holding the chain in place on the bar, feed bar and
chain into the jaw, angling over the bar locating pins
(d) and engaging the chain on the drive sprocket
(16) (See Fig. I). There is little excess chain length,
therefore, the chain must be properly fitted in the bar
slot to provide enough extra chain to be pulled over
the drive sprocket.
100mm
18
12
15
a
3mm
a
back
b
c
f
front
11
e
d
10
16
I
II
2
4
I
I
I
II
II
6
g
5
17
17
A
B3
B2
B1
C
FF
E
D
G1
I
H
G2
J
M
L
K
N
P2
P1
O