Operating Manual

Chain Saw WG303E

If the chain bar is worn out or damaged, take the chain

tensioning catch off the bar by loosing the screw anti-

clockwise. Then ﬁt the tensioning catch into the new bar

by tightening the screw clockwise. The catch protrude (a)

must be ﬁtted into the bar hole. (See Fig M)

Sharpening Chain

Have your chain sharpened professionally at your

approved service agent or sharpen the chain yourself

using the sharpening kit. Follow the sharpening

instructions supplied with the sharpening kit.

CLEANING/STORAGE

Clean the moulded plastic housing of the chain saw

using a soft brush and clean cloth. Do not use water,

solvents or polishes. Remove all debris, especially

from the motor cooling vents.

Remove and brush clean the cover plate, chain and

chain bar after 1 to 3 hours of use. Clean the area

under the cover plate, the drive sprocket and chain bar

assembly using a soft brush. Clean oil outlet with a

clean cloth.

If the chain saw is to be stored for a longer period of

time, clean chain and chain bar.

Store in a secure, dry place out of the reach of children.

Do not place other objects on the chain saw.

To prevent leakage ensure machine is left in a horizontal

position (oil ﬁller cap 4 uppermost).

When storing machine in original packaging the oil tank

must be completely emptied.