Technical data

Cordless Hedge Trimmer EN
1110
SYMBOLS OPERATING INSTRUCTIONS
WARNING! Do not use the product
without attaching the guard and
front handle.
INTENDED USE
The machine is intended for cutting and
trimming hedges and bushes in domestic use.
1. GUARD ASSEMBLY
Insert the Safety Guard (4) into the slot as
illustrated in Fig A; making sure it is securely
attached.
Use two screws to fix the Safety Guard
securely.
2. FRONT HANDLE ASSEMBLY
The Front Handle (3) must be assembled
before use:
1) Remove the bolt from the Front Handle.
2) Attach the Front Handle to the housing.
Make sure the protruding marks on the
Front Handle fit perfectly into the matching
indentation on the housing. (See Fig. B&C)
3) Insert the locking bolt into the handle and
fully tighten the bolt. (See Fig. D)
4) Check whether handle is firmly secured, if
not retighten the locking bolt.
NOTE: Make sure the handle is firmly
secured in place.
3. BEFORE USING YOUR CORDLESS
HEDGE TRIMMER
WARNING! The charger and battery
pack are specially designed to work
together so do not attempt to use any other
devices. Never insert or allow metallic objects
into your charger or battery pack connections
because of an electrical failure and hazard will
occur.
Your battery pack is UNCHARGED and you
must charge once before use.
The battery charger supplied is matched to the
Li-ion battery installed in the machine. Do not
use another battery charger.
4. CHARGING YOUR BATTERY PACK
The Li-Ion battery is protected against deep
discharging. When the battery is empty,
the machine is switched off by means of a
To reduce the risk of injury, user
must read instruction manual
Wear ear protection
Wear eye protection
Wear dust mask
Do not expose to moisture.
Do not expose to rain or water
Do not burn
Do not dispose of batteries. Return
exhausted batteries to your local
collection or recycling point.
This product has been marked
with a symbol relating to removing
electric and electronic waste. This
means that this product shall not
be discarded with household waste
but that it shall be returned to a
collection system which conforms to
the European Directive 2002/96/CE.
It will then be recycled or dismantled
in order to reduce the impact on the
environment. Electric and electronic
equipment can be hazardous for
the environment and for human
health since they contain hazardous
substances.