Technical data

1110
1110
Lawn trimmer / Lawn edge trimmer EN
only the tip of line to make contact. Do not
force trimmer line into work area.
EDGING(See Fig H)
Unscrew the upper locking knob (3) and rotate
the main and auxiliary handle to 90
o
with
cutting head (See Fig E).
Retighten the upper locking knob.
Adjust trimmer head angle to be the lowest
horizontal setting. Then position the wheel on
the ground for edge mode. The guard has two
white line guides to indicate the cutting line
position. Align these marks with the edge of
your lawn.
While edging allow the tip of the line to make
contact. Do not force the line. The rotation
wheel helps protect the unit and keeps the
unit from contacting the ground. Take extra
caution while edging as objects can be thrown
from the trimmer line.
AUTOMATIC LINE FEED SYSTEM
When initially switching on the trimmer, a
small length of line is fed out.
A ‘clattering’ noise will be heard when the
lines hit the line cutter. DO NOT BE ALARMED
this is quit normal. After about 5 seconds the
line will be cut to the correct length and the
noise will reduce as the motor receives full
speed.
If the noise of the line being cut can’t be
heard, more line will be fed out.
To feed more line, it is first necessary to allow
the trimmer to stop completely, then restart,
allowing the motor to reach full speed.
Repeat above until you hear the lines hitting
against the line cutter. (Do not repeat this
procedure more than 6 times)
TO MANUALLY FEED THE LINE (See Fig I)
If required, line can be feed out manually.
To operate, press and release manual line feed
button (16), whilst gently pull out the lines
until the lines reach the line cutter.
When the required amount of line is fed out,
gently pull on the second line (there is no
need to press the manual line feed button
again)
If the line extends past the line cutter, too
much line has been fed out.
If too much line is fed out, remove the spool
cap and click spool anti-clockwise until the line
is at the desired length.
TO REMOVE THE CAP
Press and hold in the two latches (12) (See Fig
J).
Pull cap away from the spool holder
WHEN REFITTING THE SPOOL CAP.
Keep all areas of the cap and spool holder
clean.
Replace the cap, pressing firmly down
towards the spool holder to ensure cap is fully
located.
Check that the cap is correctly fitted by trying
to remove it without depressing the two
latches.
TO REPLACE CUT LINE.
For your convenience it is recommended you
buy spool and line complete.
TO FIT SPOOL AND LINE COMPLETE:
Remove old spool.
Place new spool into cutting head.Release one
line from cleat and feed line through eyelet .
Repeat for second line.
Refit the cap.
TO FIT NYLON LINE ONLY:
WARNING! Your Trimmer is designed
to use only line with a maximum
diameter of 1.4mm.
IMPORTANT - Always wind the line onto
the upper section of the spool first.
Take approximately 5 metres of line. Insert
15mm of line into one of the holes in the
upper section of the spool and wind line in the
direction of the arrows on the top of the spool.
Leave approximately 100mm of line unwound
and place into cleat. Repeat on lower section
of spool.
Care should be taken to ensure that the line
is neatly coiled on the spool. Failure to do so
will impair the efficiency of the automatic line
feed.
Then fit spool as described in “To fit spool
and line complete”.