User's Manual

1-4
batteries to see if they need charging, displaying the following message:
Checking Batteries
Please Wait………..
4. If the batteries are already charged, the message will disappear. If
the batteries need charging, the following message is displayed:
Charging Batteries
Please Wait………..
R/F Terminal Menu Functions
There are four modes of operation for the R/F Terminal:
SIGN ON Signs R/F Terminal on for two-way communication
with host.
SETUP MODE Accesses Setup parameters for Terminal and Base.
Upon power-up, the R/F Terminal displays the following opening screen:
802 TERMINAL 3C1nnnx
ServerIP=nnn.nnn.nnn.nnn
DeviceIP=nnn.nnn.nnn.nnn
Ch:=n SSID=xxxxxxxxxxxx
WEP=Y Strength=-nn
HIT ANY KEY
(The opening screen can be bypassed upon power up. See Chapter 2)
• The first line on the screen, 802 TERMINAL 3C1nnnx, gives the
firmware revision number.
• Server IP either shows the Server's fixed TCPIP address; or if
Device searches out the Server, shows 0.0.0.0.
• Device IP either shows the Device's fixed TCPIP address or that
it is determined by a DHCP Server shows 0.0.0.0.
• Ch:=n shows the channel to start using, (the channel of the most
frequently used Access Point).
• SSID=xxxxxxxxxxxx refers to the 12 character network name.
• WEP=Y (or N) shows that the Device is configured with an
encryption key.
• Strength=-nn shows the signal strength from the best Access
Point with the same SSID
To move on to the first menu item, press any key on the R/F Terminal keypad.
The display now reads: