User's Manual

8-3
Terminal Error Messages
Message Meaning – Action Required
Waiting for Server
to Acknowledge
This is a normal message, generated when the
Terminal Device first tries to establish contact with a
Server.
No Access Point Found
The Terminal is not within range of any Access Point –
regardless of SSID or encryption settings.
Access Point Found –
Mismatch on SSID
An Access Point was found, but there was a mismatch
between Terminal and AP SSIDs
Access Point Found-
Mismatch on WKEY
Access Point with matching SSID was found, but there
was mismatch on encryption keys.
No DHCP Server Found
Terminal is configured to obtain IP Address from DHCP
Server, but it could not find a DHCP Server
Application Server Not
Found
Terminal is configured to search for Application Server,
but it could not find it.
Waiting on Host Prompt
The Server has been found. The host program has not
sent out a prompt yet. If this persists, check to see if
host application is running.
Server Shut Down Due to
Host Logic Error, Cycle
Terminal Power
Problem is in host program. Notify programmer!
If the Server detects 5 Sequence Errors in a row, or 5
messages to a Terminal not Signed In, or 5 Illegal
Commands, the Server transmits the message to all
terminals signed in and shuts down. Check your host
program and correct the logic error before starting up
again.
LOW BATTERIES
Finish, Sign Off
Change Batteries
Finish the transaction you have started. The Press F1
to Sign Out. Then turn off the Terminal and change the
batteries.
CHANGE BATTERIES
UNIT SHUT DOWN
The terminal will display this message for 20 seconds,
sign out, and turn off.
Change the batteries immediately. Don’t let someone
else pick it up and operate with partially recovered
batteries