User's Manual

2-18

Set Date

For correct date display, the 6-digit date must be set in the date format you

plan to use. By default the US terminals use the US date format of

dd/mm/yy. If you change the date format, you must re-set the date to match

the new format. For example, to set a date of January 20, 1999, you would

enter 012099 (US format) or 200199 (European format). The date can be

scanned in from the bar coded Setup Menu or entered from the RF Terminal

keypad. To display the date during operation, press the STATUS key.

Set Time

The time is set using a 4-digit military hhmm format. For example, to set

the time to 3:08 p.m., you would enter 1508. The time can be scanned in

from the bar coded Setup Menu or entered from the RF Terminal keypad.

To display the time during operation, press the STATUS key.

Display of Year

2 digit 0

4 digit 1

• By default, the RF Terminal is configured to display and transmit the

year in a 2-digit format; i.e. 2005 would transmit and display as 05.

• Before you change the RF Terminal to display a 4-digit year, i.e. 2005,

make sure that the software receiving data from the RF Terminal is set

up to accept a 4-digit year.

Voice Message Partitions

This parameter partitions the total amount of voice messages into different

message lengths. The default setting is:

303015

xx yy zz

where: xx is number of ½ second messages

yy is the number of 1-second messages

zz is the number of 2-second messages

The total time allotted must not exceed 75 seconds. To change the partitions, scan

or enter 6 digits total; 2 for the number of ½-second messages, 2 for the number

of 1-second messages and 2 for the number of 2-second messages. See the

default setting as an example.

WARNING: changing the Voice Message Partitions parameter after you

have recorded messages could result in having to re-record some of them;

they would still be there but longer messages may get cut up and shorter

ones combined.

Other

ate/

Time