User's Manual

6
Installing the R/F Reader between a computer and
terminal
If you attach the s Base between your computer and a terminal, as shown
below, using Cable Selection F45-1, bar code data will be sent to the computer
as if it had been typed on that terminal. Refer to page 8 for the details of the
pin-outs for each connector on the cable. You will also need to change jumpers
(JP2 on the RF Base) on the board inside the case from the “S” position to the
“Y” position.
Cables may require modification, depending on the genders and pin-outs of
your serial ports and cables. You may require "gender changers" (available at
most computer stores) for the two 25-pin connectors. Refer to page 8 for the
details of the pin-outs of the dual port serial cable.
Turn to page 8 to configure the your reader using the RF Laser Reader Setup
Menu.