Service manual

– 29 –
GENERAL ADJUSTMENTSSPECIFIC INFORMATIONS
PROGRAMMING CHANNEL MEMORY
The channel memory is the list of TV channel numbers the TV tunes when you press the CHANNEL s or t button.
First, use the TV/CABLE and CH PROGRAM functions to preset all active channels in your area automatically.
If necessary, arrange the preset channels with the ADD/ERASE functions so that you can tune into only desired channels.
Note: If you utilize both ANT-1 and ANT-2 terminals for some model, perform programming channels for each input source.
TV/CABLE function
1
Press MENU, then press t (or s) until the SYSTEM
OPTION menu appears.
2
Press : once.
3
Press t (or s) until "Signal Type" is highlighted.
4
Press : once.
5
Press s (or s) to highlit either "AIR/CABLE" which ever you
use.
CH PROGRAM function
1
Select “CH SEARCH” following steps 1 and 2 above.
2
Press t (or s) until "Channel Search" is highlited.
3
Press : once.
4
Press S (or T) selecting Ch Search mode.
5
Press ENTER/OK once.
Full Search : Search will be performed for both Ant A
and B and they will automatically be set to
Cable or Air.
Quick Search : Current Ant mode
Current Air/Cable mode
Search only above.
EDIT Channel
1
To erase a channel, select the channel you desire to
erase by Edit Channel in TV, Setup of Profile Menu, and
subsequently press the OK key.
2
To add a channel, take the same steps as in the case of
erasure mentioned above. The channel is added when
a check "✓" is on, and it is erased when the mark is off.
Concerning the channel not found in the Edit Channel, use
the 10-key and select the station directly. The channel will
then be automatically added if it has a signal.
* Please refer to owner's manual in detail.