Specifications

Alignment and Adjustments
Samsung Electronics 4-13
1. Warm up the TV for at least 30 minutes.
2. Input a PAL Signal. (Use an antenna or AV source.)
Make sure that both deflection and convergence yokes are
properly adjusted so that the center of Green, Red, Blue pattern
is aligned on the center of screen jig.
3. Enter the Convergence Mode by pressing the remote control keys in the following sequence:
If OSD is displayed as shown in figure below, press the key to exit.
Then, redo step 3 to enter the Convergence Mode.
After entering the Convergence Mode, Stand by for about five seconds before
doing the adjustments.
NOTE
NOTE
S.STD
R/B
4-7 Convergence Adjustment