Operating instructions

7
Installing the R/F Reader between a computer and
terminal
If you attach the Wireless Base between your computer and a terminal, as
shown below, using Cable Selection F45-1, bar code data will be sent to the
computer as if it had been typed on that terminal. Refer to page 8 for the
details of the pin-outs for each connector on the cable. You will also need to
change jumpers (JP2 on the RF Base) on the board inside the case from the
“S” position to the “Y” position.
Cables may require modification, depending on the genders and pin-outs of
your serial ports and cables. You may require "gender changers" (available at
most computer stores) for the two 25-pin connectors. Refer to page 8 for the
details of the pin-outs of the dual port serial cable.
Turn to page 9 to configure the your reader using the Wireless Setup Menu.