Owner`s manual

Terminal Error Messages
112
Message Meaning – Action Required
“Initializing Radio Unit” This is a normal message, generated when you first establish radio contact. If you continue to get
this message and it results in a "Transmission Failed" message, makes sure your Access Point
setup is correct.
“Waiting on Host Prompt” Problem is between Connection Host and Application Server. Check to see if Application Server is
running. Check Connection Host setup. Run the default Connection Host and demo Application
Server.
“Server Shut Down Due to Host Logic Error,
Cycle Terminal Power”
Problem is in host program. Notify programmer!
If the Application Server receives 5 Sequence Errors in a row, it transmits the message to all
terminals signed in and shuts down. Check your host program for the sequence error before
starting up again. OR
If the Application Server receives 5 messages addressed to a Terminal not Signed ON, it transmits
this message to the all terminals signed in and shuts down.
You will have to restart the Application Server or you can send a command (*@EOT) from the
server and have the Terminal Sign On again to continue.
LOW BATTERY Finish, Sign Off Charge
Battery
Finish the transaction you have started. The Press F1 to Sign Out. Then turn off the Terminal and
charge the battery. This is an early warning that the battery is getting low and should be charged
soon.
CHARGE BATTERY UNIT SHUT DOWN The terminal will display this message for 20 seconds, sign out, and turn off.
The unit will not operate until the battery is charged.
Transmission Failed To Retry, Move Closer
And Press Enter
The terminal has tried 10 times to get its message through to the Host with no success. Could be
result of bad radio in AP or terminal. Could be the operator has gone out of range of the AP - if so,
move closer and press any key. Could also be that there are too many terminals competing for
radio time on one AP.
No Firmware Detected
1 – Download Firmware
0 – Power off Terminal
Press 0 or 1 now_
The firmware has somehow been wiped out – probably from an interrupted firmware download.
Press 1 to Download Firmware or press 0 to power off the terminal.