User Manual

ManualsBrandsWorldlinks Communications ManualsAudio EquipmentSpeaker

Introduction

Thank you for choosing the BTS200 as your source for

e n t e r t a i n m e n t ! , you can use this item with iPads,iPhones,

iPods and many types of smartphone to stream music ,

and enjoy handsfree calling.In order to get the best results

when using the device,please read this manual first before using.

Important Waterproof/Safety Information

Important: DO NOT submerge the BTS200 speaker in water,this unit is

not intended to function properly after being under water.

BTS200 is rated IPX6,which means the speaker can be heavily

splashed with water or left in the rain(but not submerged in water)

for approximately a limited time.If the BTS200 gets wet,it is

recommended that you dry the speaker completely before using it

again.

Please note:Speaker is not water-resistant when the silicone cover

is open.please make sure that cover is closed and secure before

using in a wet environment.

Summary of content (5 pages)

PAGE 1
Introduction Thank you for choosing the BTS200 as your source for e n t e r t a i n m e n t ! , you can use this item with iPads,iPhones, iPods and many types of smartphone to stream music , and enjoy handsfree calling.In order to get the best results when using the device,please read this manual first before using. Important Waterproof/Safety Information Important: DO NOT submerge the BTS200 speaker in water,this unit is not intended to function properly after being under water.
PAGE 2
Description: 1.ON/OFF button 2.Play/Pause/Phone 3.MIC 4.Previous/Volume – 5.Next/Volume + 6.Blue LED(Bluetooth) 7.Red LED(Charging) 8.Green LED(AUX) 9.Micro USB Charging Port 10.AUX in Port Included: 1.Speaker 2.USB Micro Charging Cable 3.3.5 mm Audio Cable 4.
PAGE 3
Specifications Supported Profiles: A2DP, HFP, AVRCP Bluetooth Range:33ft (10m) Dimensions: 180 mm x 65 mm Battery: Li-Ion 3.7V, 1000 mAh Charging: 5V @ 500 mA Operation Powering On Press and Hold "ON/OFF" button 2 seconds to power ON, the Blue LED will start to flash. If an Aux (3.5 mm) cable is connected to the unit, the Blue LED will turn off, and the Green LED will stay illuminated,notifying you, the uint is in Aux-In mode. .
PAGE 4
Aux-In Mode Plug in the supplied 3.5 mm cable into the unit. The other end is connected to your device. The Green LED will only illuminate when in “Aux” mode. Please note music and volume can be controlled by your device. Charging Attach the USB cable to the unit, and plug into any USB charger. If the unit is completely discharged, it will take approximately 4 hours to fully charge. The Red LED will illuminate during charging, when it has completed, the Red LED will turn off.
PAGE 5
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.