User's Manual

C-ZAM/XENTA
PRODUCT GUIDE
o V.42 / MNP4 and V.42b / MNP5 error correction and data compression, V.44 data
compression
o Tone and pulse dialling
o Communication speed up to 57.600 bps, which is beneficial for remote software
downloads
- Marked “Ethernet”
( )” is a 10 Base-T interface, connector type RJ45
o To communicate with a host, to create a LAN using a TCP / IP connection
according to IEEE 802.3
o Ethernet encapsulation for IP-protocol, IP address, subnet mask & gateway
o Communication speed up to 10 Mbps
o Logic integrated in the SAMOA ASIC
o Ethernet offers a fast interface for development purposes
Others
The terminal is equipped with a reset button (rear side). A tool is needed to push this
button.
Reset button
The terminal housing has a light grey colour on the outside (NCS S2502-B) and a blue-
grey colour on the inside (NCS S5020-R80B)
Power adapter
A universal tabletop adapter (for indoor use) in combination with different country-specific
adapter cables will power the C-ZAM/XENTA terminal.
The adapter input is 100 / 240 VAC - 50 / 60 Hz - 0,7 A. The output is 6,5 VDC - 3,05 A.
The attached cable has a standard length of 2 m and should fit to the power connector of the
terminal or merchant unit.
The separately available adapter cables have a standard length of 2 m and a country-
specific plug to fit the different wall sockets.
Version: 1.0 12