Owner`s manual

HOOKUP DIAGRAM
Please refer to the following scenario for connecting the PANDA200.
1.Connect a USB cable from your computer to the PANDA200. The unit will be powered
through the USB connection. Alternatively, if you do not wish to use a computer in your
setup or if you wish to power the PANDA200 externally, please plug in the included 9V-1A
DC power adapter.
2.If you would like to use an external sound module, connect a 5-pin MIDI cable from the
MIDI OUT of the PANDA200 to the MIDI IN of the external device.
3.If you would like to use Footswitches or an Expression Pedal with the PANDA200,
connect the 1/4" jack from the selected pedal in to the appropriate plug on the
PANDA200.
A NOTE ABOUT USING THE PANDA200 WITH SOFTWARE
1. Make sure that the PANDA200 and all external devices are connected and that the
USB cable is connected to your computer before opening any software applications
with which you intend to use the PANDA200. If the unit is not plugged in before, your
software application might not recognize the PANDA200 as an available device.
2. In your software application, you will need to set the PANDA200 as a default MIDI
input device. This is usually done in the MIDI section of the Preferences menu.