User's Manual

COMMUNICATION CERTIFICATION LABORATORY TEST REPORT: 73-6907
FCC ID: NQE-900UHOPPER
Page 72 of 103
Exhibit 8
Installing the Software
You are now ready to install the software.
1. Turn on your computer and start Windows.
2. Insert the first Install disk in your disk drive.
3. Click the Windows “Start” button, point to “Run”.
4. In the “Open” box type “a:setup” and press Return.
5. Follow the instructions on your screen, inserting the remaining disk(s) when
prompted.
You are now ready to use the Hopper Radio Configuration program.
Performing a Quick Start Radio Test
1. Launch the Configuration program by clicking “Start” then “Programs” then “Hopper
900 Configuration”. You should see the screen as shown below.
2. Select the appropriate COM port to which the radio is connected.