User's Manual

COMMUNICATION CERTIFICATION LABORATORY TEST REPORT: 73-6907
FCC ID: NQE-900UHOPPER
Page 74 of 103
Exhibit 8
WWC Micro Hopper Data Radio
General Information
The Data Radio is a frequency-hopping data transceiver operating in the 902-928 MHz
ISM band. The transceiver is designed to operate under Part 15 of the FCC rules and
regulations and is designed as an OEM module for professional integration into other
products or field devices. When installed using one of the approved World Wireless
Communications antennas listed below, the user need only make sure the radio’s FCC
label or a copy of the FCC label is clearly visible on the outside of the integrated
product.
In order to comply with FCC Section 15.203 the 900 Micro Hopper Data Radio
was tested with and can only be installed with the three different types of antennas
listed below:
Antenna Type Model Antenna Gain
Dipole 0 dBi
Comtelco Yagi Y2283A-66 6 dBi
Maxrad Omni MFB9155 5 dBi
In order to comply with the FCC RF exposure requirements the Data Radio must
be installed with the antennas listed above and a minimum separation distance of 20
cm must be maintained from the antenna to the user.
Caution: When this radio is integrated into another product, the OEM is responsible
for complying with the external labeling requirements as directed in the FCC Rules and
Regulations part 15.19. The user may only use antennas that have been tested and
approved with this radio without obtaining their own FCC certification.
The unit operates on 25 discrete frequencies within the ISM band. Using a high-speed
phase-locked loop synthesizer, the receiver is able to quickly acquire synchronization
with the transmitter and receive the transmitted data.