User's Manual

COMMUNICATION CERTIFICATION LABORATORY TEST REPORT: 73-6848
FCC ID: NQE-900SSHOPPER
Page 81 of 109
Exhibit 8
bytes.
(vii) CTS Assert
CTS (Clear to Send) Assert, also known as “flow control on,” has a default
setting of 100 bytes.
(viii) CTS De-Assert
CTS De-Assert, also known as “flow control off,” is defaulted to 125 bytes.
(ix) TX Assert
The volume or amount of time the transmitting radio will collect or wait
before it transmits. Default is 10 mS.
(x) CD Level
Carrier Detect level. Lets the scanning radio determine if there’s a valid
signal to receive. This is a factory alignment setting.
(xi) Group Code
Lets you set any number of radios to the same group. There are 1600
available groups. Radios with different group codes will not receive each
other. The data radio’s default setting is Group 1.
(xii) Deviation
This is a factory alignment setting.
(xiii) TX Power
This setting allows the user to change the transmitter output power. This
feature is not supported on all products. The default setting is “high”.
(xiv) Frequencies
Number of frequencies available for the data radio to scan. Choices for
this setting vary with radio model.