User's Manual

COMMUNICATION CERTIFICATION LABORATORY TEST REPORT: 73-6848
FCC ID: NQE-900SSHOPPER
Page 78 of 109
Exhibit 8
WWC 900 SS Hopper Data Radio
General Information
The Data Radio is a frequency-hopping data transceiver operating in the 902-928 MHz
ISM band. The transceiver is designed to operate under Part 15 of the FCC rules and
regulations and is designed as an OEM module for professional integration into other
products or field devices. When installed using a World Wireless Communications
approved antenna, the user need only make sure the radio’s FCC label or a copy of the
FCC label is clearly visible on the outside of the integrated product.
In order to comply with FCC Section 15.203 the 900 Micro Hopper Data Radio
was tested with and can only be installed with the three different types of antennas
listed below:
Antenna Type Model Antenna Gain
Small Dipole 0 dBi
Large Dipole 3 dBi
Comtelco Yagi Y2283A-66 6 dBi
Maxrad Omni MFB9155 5 dBi
In order to comply with the FCC RF exposure requirements the Data Radio must
be installed with the antennas listed above and a minimum separation distance of 20
cm (for the Dipole’s and Omni antennas) and a minimum separation distance of 40 cm
(for the Yagi antenna) must be maintained from the antenna to any near by persons.
Caution: If this radio is integrated into another product, the user is responsible for
complying with the external labeling requirements as directed in the FCC Rules and
Regulations part 15.19. The user may only use antennas that have been tested and
approved with this radio without obtaining their own FCC certification.