User's Manual

COMMUNICATION CERTIFICATION LABORATORY TEST REPORT: 73-6848
FCC ID: NQE-900SSHOPPER
Page 75 of 109
Exhibit 8
WWC 900 SS Hopper Data Radio
Quick Start Guide
Contents
The World Wireless Communications 900 SS Hopper Developer Kit contains the
following items:
•
User’s Guide with technical diagrams
•
900 SS Hopper Radios with an attached RS-232 Interface Board
•
900 Megahertz Antennas
•
12-volt, 1.2 amp DC Power Adapter
•
Serial Data Cables with 9-pin connectors
Getting Started
You will need to supply the following items:
•
An RS-232 terminal or a computer (PC) running a communication software
package
•
A serial COM port for connecting the terminal or computer to the radio
•
A 120-volt AC power source for the radio power supply
•
A standard 25-pin to 9-pin adapter if your PC or terminal does not have a 9-pin
serial port available
Setting up the Radios
1. Locate the antennas and install them on the antenna connectors of the
Hopper radios. Set the radios with antennas aside in a safe place.
2. Remove the 9-pin serial cable from the box and attach it to an available
serial COM port on your PC or terminal. If the port has a 25-pin
connector, use the appropriate adapter, which is not supplied with this kit.
3. Attach the other end of the serial able to the radios.
4. Plug the power supply into a 120-volt AC outlet. Power up the radio by
plugging the cable from the power supply into the radio.
If you are using a terminal or a PC with a communications program other than the Data
Radio Configuration program, set the communications parameters of your terminal to
9600 baud, 8 data bits, no parity, and one stop bit. You will also want to enable “local
echo” or “half-duplex” mode so that the characters typed will appear on the screen as
well as be sent to the radio.