User manual

3MC1000 - NTP Time Reference System - User Manual - Version 2.0
Section 1: Introduction
1.4 - LCD time and status displays
In normal operation, the liquid crystal display (LCD) shows the local
time, the local date and the offset from UTC. The MC1000 also has
three status display screens accessible via the ‘STATUS’ switch. The
status display screens show basic information from the connected
antenna systems and the status of the network interface.
1.4.1 - Standard time and date display
No. Function No. Function
19
Local time
21
Offset from UTC
(replaced by ‘SYNC ERROR’
if the time has not been set)
20
Local date
22
Daylight saving time indicator
Table 1.3 - Standard time and date display functions
1.4.2 - Sync 1 & Sync 2 status displays
The Sync 1 status display is accessible by pressing the ‘STATUS’
switch on the front panel. With a further press of the status switch, a
similar Sync 2 status display is shown.
No. Function No. Function
23
Antenna system type
24
Antenna status
Table 1.4 - Sync 1 status display functions
1.4.3 - Network status display
The Network status display is located after the two sync status
display screens. This can be accessed by a further depression of the
‘STATUS’ switch. Press the status switch again to exit.
No. Function
25
Network status
Table 1.5 - Network status display functions
23
24
25
21
2220
19