User manual
11MC1000 - NTP Time Reference System - User Manual - Version 2.0
Section 5: Remote access
Information transmitted using the Telnet protocol is unencrypted,
therefore care should be exercised when using this function in certain
applications. Telnet access is disabled by default. Please refer to
section 5.1.3 for details of how to enable Telnet access.
5.1.3 - Enabling / disabling HTTP / Telnet access
The MC1000 is supplied with HTTP access enabled and Telnet access
disabled. The graphic below shows how the current access settings
can be conrmed and, by way of example, Telnet access enabled:
5.2 - Remote access via the USB interface
The supplied MC1000 Interface software application enables the
MC1000 to be fully programmed from a remote PC via the USB
interface. All settings normally accessed using the front panel switches
can be conrmed and adjusted using this software application. The
software is also used for downloading upgraded software versions
into the MC1000 (see section 7).
The software is supplied with the MC1000 on a CD-ROM. Copies are
also available for download from the World Time Solutions web site:
http://www.worldtimesolutions.com
ENTER
ENTER
SETUP ENTER